stupid mouse....

[struka]

ate my wires.
Anyone knows what these are so I can look them up and wire them back up? Car runs fine without it seems since I just found it yesterday and I have been driving it around.

[FooSchnickens]

Grey connector looks like a temp sensor, but I cannot into 240 wiring so I could be totally wrong.

[struka]

found out one wire connector is temp, two wire is knock sensor.

I need to look at it some more. Since one is a knock sensor, I would figure the car would be acting up but seems to be doing fine. I wonder if that has something to do with the Enthlapy ECU that I have.

[Zenkis14]

found out one wire connector is temp, two wire is knock sensor.

I need to look at it some more. Since one is a knock sensor, I would figure the car would be acting up but seems to be doing fine. I wonder if that has something to do with the Enthlapy ECU that I have.

If this is an SR or KA, those should both be temp sensors, one sends signal to ECU the other sends signal to gauge on dash. The knock sensor is located underneath the intake manifold directly on the block.

[struka]

found this:

http://forums.nicoclub.com/1991-1994-24 ... 53121.html

So looks like it is the knock and the temp gauge for the cluster.

Thanks!

[icantdrift]

Yeah, those. Why not just rewire the plugs? Doesn't matter what they are, the wire colors match up

[struka]

that's what i am going to do.

one plug has wire chewed up all the way down to the base so it will be hard to solder.