Was having my buddy who runs a shop put my knuckles on yesterday, turns out they are made from S13 knuckles. So, I either buy S13 hubs and ball joints, or sell this stuff and just get new knuckles to go with my S14 hubs and ball joints. Turns out it will be cheaper for me to just sell this stuff and get new knuckles. So, if you have a S13, you're in luck.
Bought the knuckles from a local dude a while back, and as far as I know, they've never been used. SPL outer tie rods are unused as well.
MA Motorsports Knuckles - $180, same as i bought them for
SPL outer tie rods - $210, few bucks off because they are a bit scratched from mocking them up on my car
I can hand deliver them when I come down for FD Atlanta.
FS: MA Motorsports Knuckles, SPL outer tie rods
Moderators: charlie, darkducati, CodyW, Rhoad Racing
- revel
- Eet Bacon
- Posts: 7666
- Joined: Wed Jul 28, 2004 6:00 pm
- Location: DeepDishDreams&StretchedTireNaps
FS: MA Motorsports Knuckles, SPL outer tie rods
Hmmmmmmmmmmmm
- icantdrift
- Salsa Rodeo
- Posts: 5987
- Joined: Fri Sep 03, 2004 1:03 pm
Re: FS: MA Motorsports Knuckles, SPL outer tie rods
revel wrote:Hmmmmmmmmmmmm
yes.... quite.
but I'm not sure I want to go through with drilling out the lower balljoint hole again.
- revel
- Eet Bacon
- Posts: 7666
- Joined: Wed Jul 28, 2004 6:00 pm
- Location: DeepDishDreams&StretchedTireNaps
FS: MA Motorsports Knuckles, SPL outer tie rods
I will take the knuckles!
Re: FS: MA Motorsports Knuckles, SPL outer tie rods
sorry i didn't keep this updated. jarrod boughted 'em.
Re: FS: MA Motorsports Knuckles, SPL outer tie rods
fail boat by koopa lolz