collink wrote:

struka wrote:i just used the backseat latch and bolted it to the tunnel where the seat attaches

Ahh, that's a good idea.

Is it uncommon for your seats to sit like 2" higher than stock on Megan Racing brackets?

why buy name brand when you can buy and uneducated copy.

haha yup thats why I made strukas the way I did to get it as low as we could with out modifying the floor pan. I made one for TC but he is pretty much like 5'3" and so had it sitting up high.

lolz

Dangerous Drifter Dan wrote:haha yup thats why I made strukas the way I did to get it as low as we could with out modifying the floor pan. I made one for TC but he is pretty much like 5'3" and so had it sitting up high.

You wouldn't be able to reproduce those brackets, would you?

collink wrote:

Dangerous Drifter Dan wrote:haha yup thats why I made strukas the way I did to get it as low as we could with out modifying the floor pan. I made one for TC but he is pretty much like 5'3" and so had it sitting up high.

You wouldn't be able to reproduce those brackets, would you?

are you trying to use the sliders too or just the brackets?

matts13 wrote:

collink wrote:

Dangerous Drifter Dan wrote:haha yup thats why I made strukas the way I did to get it as low as we could with out modifying the floor pan. I made one for TC but he is pretty much like 5'3" and so had it sitting up high.

You wouldn't be able to reproduce those brackets, would you?

are you trying to use the sliders too or just the brackets?

sliders and brackets...

that is why. they are not intended to use sliders. fix mount=good to go.

i want to redo mine and get mine even lower. i dont hit the cage on a normal drive but i do hit it with the helmet.

matts13 wrote:that is why. they are not intended to use sliders. fix mount=good to go.

I'm not sure I can fix mount them without drilling the brackets...even if I could, I think that the seat would sit HELLA far back...

Thanks for the suggestion Matt. It worked out well. The bolt holes for the front matched right up on the mounting bracket, however the rears were about 2.25" too far forward and about .5" inside of the bracket, so I visited a local steel shop and had them cut me 2 pieces (2" x 3.5") of .25" thickness steel and I drilled holes out to make adapter brackets.

struka wrote:i want to redo mine and get mine even lower. i dont hit the cage on a normal drive but i do hit it with the helmet.

you'll have to mod your floor pan where the cat hump is.

hurray for hammers!!!!!

i moded my hump

Dangerous Drifter Dan wrote:

struka wrote:i want to redo mine and get mine even lower. i dont hit the cage on a normal drive but i do hit it with the helmet.

you'll have to mod your floor pan where the cat hump is.

i modded your moms hump