So I need tie rods for my S13. any suggestions ? thanks

i run JIC inners with KTS outers on my 14 and i love it. not necessarily the cheapest setup out there (i think they were about $300), but it's a damn beefy combo. got me a bit of extra angle too, which is nice.

lol look at those iddy bitty brakes.

at least they aren't on fire in that pic...haha. that wasn't fun.

right arm man, not looking for cheap. would love more angle i may see if that set up will work on an S13. thanks again man

CodyW wrote:

at least they aren't on fire in that pic...haha. that wasn't fun.

hahha! quick! pour a mountain dew on it to put out the flames!

yeah they work on a 13 you may have to cut a little off the inner may not depending on the outer end you use. kinda test and see. i have the tein harden for a s14 and some kts or somthing like on cody's. also get new rack boots when you do it makes it look all that much better.

There's a few people round about that run the tein full setup and they seem to love it. They say it adds a good bit of angle and its a whole lot beefier.

I heard the SPL Parts set up was the way to go.

SPL= serious parts for serious loot. rich bitches only. i cant hang.

hey if you are lookin for something cheap and of descent quality, i have had mine for a lil while now and i can't complain about em. completly identical to the kts, kazama, etc. rods and rod ends. i compared with a friends and they are the same. i paid 155 for the inner and out from phase2. also the megan tension rods are quite beefy as well. added those with the tie rods and still no complaints.

i say spl....i will not by anything that is megan racing.

91 mazda mpv outters

z32 inners

haha