If you e a nitrous junkie install a Jacobs Electronics Nitrous Mastermind and you won have to worry about melting your mill. The best thing about the Nitrous Mastermind is its ability to flow nitrous in proportion to rpm. Youll get more power safety and traction without hurting anything even with two-stage systems. It prevents detonation by retarding timing on nitrous ends burned pistons by shutting off nitrous if fuel pressure drops stops destructive over-revving with a feather-touch rpm limiter and prevents nitrous from turning on under a set rpm. This unit is fully adjustable from the dash and is compatible with all nitrous systems. Its designed for use on V8 engines.This item carries CARB E.O. Number D-19-10 for use in California.The Nitrous Mastermind must be used with an upgraded ignition system.
andysapp wrote:They sell that shit at Summit. Maybe I could get it. $250 is worth not blowing my motor ups... but it would also be another thing to try and install.
looks like nitrous is a no-go. just talked to brett and the problems with the stock ecu far outweigh the gain. i'll explain more in depth in a bit.
