since the other thread is kinda getting off topic, how about you list if your car shoots fire and if so, whats done to it. i'll start.
'91 RX7 TII
- 3" turbo back exhaust
- cone filter
- Greddy Type-S BOV vented to atomosphere
- lots of others but those are the main ones for fire balls.
the stock ECU on any 7 is set up for recirculated BOV's. so when you vent it, the ECU thinks its getting lots more air and dumps TONS of fuel in. obvious not all the fuel gets burned up and then ignites in the exhaust due to the 1600* exhaust temps. and BLAM! fire balls.
the rear bumper over my exhaust on my car is burned black from all the flames the car shoots. no paint is left there.
all my mods and a couple pics are in the link at the bottom of my sig for those who're interested.
Last edited by Kouki7 on Mon Jun 14, 2004 11:13 am, edited 1 time in total.
you definately can't have ANY restrictions in your exhaust. IE: no CATs. it doesn't matter how much boost your pushing, its just the fact of having unburned fuel make it to the exhaust pipe. when my 7 was N/A it would blow fire.
Mine does: '03 EVO with 3in HKS Hi-Power all the way back. 3 in test pipe and downpipe included. My HKS RS leans out mixture in mid range so i only get flames on the top end unless i run VTA. Turbo cars rule
The 2 best fighter jets for the greatest airforce in the world.
Roy's STi tends to shoot flames when we increase the boost after the motor has been running low boost long enough for the computer to readjust to those settings. As for Kouki7's RX-7, you are lucky i suppose in the fact that you will probably shoot the most flames of all of us simply becuase of the design of your engine. Since there is a little overlap between exhaust and intake, unburnt fuel tends to make it through the exhaust port. It is a little harder in Piston engines, however I have noticed that the EVO 8 seems to do it quite often without cats and a few mods.
-Patrick