Tie Rods

expo · Post by **expo** » Fri Jan 05, 2007 5:03 pm

So I need tie rods for my S13. any suggestions ? thanks

CodyW · Post by **CodyW** » Fri Jan 05, 2007 5:31 pm

i run JIC inners with KTS outers on my 14 and i love it. not necessarily the cheapest setup out there (i think they were about $300), but it's a damn beefy combo. got me a bit of extra angle too, which is nice.

Greg · Post by **Greg** » Fri Jan 05, 2007 5:32 pm

lol look at those iddy bitty brakes.

CodyW · Post by **CodyW** » Fri Jan 05, 2007 5:33 pm

at least they aren't on fire in that pic...haha. that wasn't fun.

expo · Post by **expo** » Fri Jan 05, 2007 5:33 pm

right arm man, not looking for cheap. would love more angle i may see if that set up will work on an S13. thanks again man

Post by **andysapp** » Fri Jan 05, 2007 5:46 pm

CodyW wrote:

at least they aren't on fire in that pic...haha. that wasn't fun.

Greg · Post by **Greg** » Fri Jan 05, 2007 5:47 pm

CodyW · Post by **CodyW** » Fri Jan 05, 2007 5:56 pm

hahha! quick! pour a mountain dew on it to put out the flames!

matts13 · Post by **matts13** » Fri Jan 05, 2007 6:54 pm

yeah they work on a 13 you may have to cut a little off the inner may not depending on the outer end you use. kinda test and see. i have the tein harden for a s14 and some kts or somthing like on cody's. also get new rack boots when you do it makes it look all that much better.

Zach · Post by **Zach** » Fri Jan 05, 2007 7:17 pm

There's a few people round about that run the tein full setup and they seem to love it. They say it adds a good bit of angle and its a whole lot beefier.

Frosty_SPL · Post by **Frosty_SPL** » Fri Jan 05, 2007 7:23 pm

I heard the SPL Parts set up was the way to go.

revel · Post by **revel** » Fri Jan 05, 2007 8:42 pm

SPL= serious parts for serious loot. rich bitches only. i cant hang.

ChokingVictim · Post by **ChokingVictim** » Fri Jan 05, 2007 11:17 pm

hey if you are lookin for something cheap and of descent quality, i have had mine for a lil while now and i can't complain about em. completly identical to the kts, kazama, etc. rods and rod ends. i compared with a friends and they are the same. i paid 155 for the inner and out from phase2. also the megan tension rods are quite beefy as well. added those with the tie rods and still no complaints.

struka · Post by **struka** » Sat Jan 06, 2007 2:46 am

i say spl....i will not by anything that is megan racing.

mikespeed95 · Post by **mikespeed95** » Sat Jan 06, 2007 2:52 am

91 mazda mpv outters

z32 inners

haha