16x7 +38 on the fronts with a 5mm spacer. 16x8 +0 on the rears. the rears are sticking out around 1/2inch. so rear fenders will need to be rolled/pulled and i need to put some 15mm or 20mm spacers and longer wheel studs on the fronts.
anyway heres the pics:
anyone got any nice 15mm or 20mm spacers they'd sell me? oh and longer wheel studs?
Last edited by revel on Wed Jan 10, 2007 2:38 am, edited 1 time in total.
That shit looks good man now it just needs to be slammed down to the ground
you can find the wheel studs from ARP on Summitracing.com it's like $55 to replace all of them and have 4 left over if you're 4 lug.
thanks guys. to run the fronts....and have them look right with those 16x8s.....i think i am going to need like 15mm or 20mm spacers and the arp studs. the sportmax 002s are light. really light. weigh 33.5lbs with 205/45s. the rota gt3s weigh 40lbs with 205/50s. my only complaint is that the bolt holes are deep and tight. too tight for the lugs i was using. had to find a new set that fit better.
now to find spacers, lower springs, and some fender rollage.
i finally have my imitation-baller wheels on the way but i think i'm gonna wait til i get coilovers and roll my fenders as well so i won't look silly with them on my car the way it is now.
