Cage w/ Door Bars and racing seats in S14

collink · Post by **collink** » Mon Jul 21, 2008 4:26 pm

How hard is it for you to fit a cage in an S14? It feel like there is literally NO room between the door panel and the seat...

Struka, maybe you could provide some insight?

down_shift · Post by **down_shift** » Mon Jul 21, 2008 4:38 pm

please rephrase.

Generz · Post by **Generz** » Mon Jul 21, 2008 4:40 pm

You remove the seat and install a vertical bar sticking straight up where the seat is and then accommodate the rest of the cage from there.

Make sure you use the correct diameter tubing or that cage will NOT be legal.

matts13 · Post by **matts13** » Mon Jul 21, 2008 5:16 pm

remove door panels and rest of trim. all the sudden you have plenty of room to put a cage in it.

Greg · Post by **Greg** » Mon Jul 21, 2008 5:18 pm

but but I want a bolt-in cage and full interior.

P.Haire · Post by **P.Haire** » Mon Jul 21, 2008 7:47 pm

that's the only way to be a baller

collink · Post by **collink** » Mon Jul 21, 2008 8:16 pm

I have no problem pulling the back seat and stuff...I'd just prefer to have as much interior as possible, seeing as it's still my DD.

matts13 · Post by **matts13** » Mon Jul 21, 2008 8:18 pm

dd should not have cages

struka · Post by **struka** » Mon Jul 21, 2008 8:24 pm

matts13 wrote:dd should not have cages

agreed. unless youre doing a 4pt....

my cage was hard to fit in cause its really tight and sits high. a cage that is for a full interior will suck cause its going to be low with the roof.

DrifterMama · Post by **DrifterMama** » Mon Jul 21, 2008 9:25 pm

why are you even asking this question?

Greg · Post by **Greg** » Mon Jul 21, 2008 9:27 pm

collink wrote:I have no problem pulling the back seat and stuff...I'd just prefer to have as much interior as possible, seeing as it's still my DD.

PmartyX · Post by **PmartyX** » Mon Jul 21, 2008 9:29 pm

matts13 wrote:dd should not have cages

+10000000000000000

CodyW · Post by **CodyW** » Mon Jul 21, 2008 9:34 pm

i'm confused.

mine fits though. it's tight, i had to cut out part of the door panels.

old shot from when my interior wasn't pretty

don't know if those will do any good, but maybe they will.

collink · Post by **collink** » Mon Jul 21, 2008 10:03 pm

That's the idea right there Cody.

I'm not going full 10-point. I was considering S&W's 8-point. The main hoop with supports inside and behind, and the door bars. No bars over the doors to break my head with...

Did you have that cage done custom Cody? Or did you buy a weld-in one?

CodyW · Post by **CodyW** » Mon Jul 21, 2008 10:04 pm

mine's just an autopower 6 point with modified door bars